.png)
LISEC CUTTING SYSTEM
CUTTING SYSTEM + LOADER INCLUDED!
Was: $125,000
​
NOW: $85,000 (35% off!)
Make: Lisec 2007071816/2007
General Description: 2007 Lisec 10 station jumbo storage system with 2 sided loader, cutting, and breakout table. Currently in daily use in good working condition
Model: 2 sided Loader and 10 rack storage system
Type: ATH-60-30D
Year: 2007
SER. N.: 012-041732
Voltage: 220v
Frequency: 60/ 3phase
Power: 20.5 Amp
Air: 8 Bar (116psi)
Weight: 6480kg (14,256lbs)
General Information: This double-sided glass loading machine unloads glass sheets from storage racks positioned on either side of the machine, and automatically tilts them horizontally for the next step towards the cutting process. Both the tilt mechanism and the frame with its vacuum suction cups are hydraulically operated. - 10 station storage system (5 stations on either side of 2 sided loader).
​
-Min Glass Sheet Size: 2800mm x 1600mm (110” x 62”)
-Max Glass Sheet Size: 6000mm x 3300mm (236” x 130”)
​
Condition: Good working condition with brand new air/power/communication cabling. No repairs are needed
​
​
Model: Glass Cutting Table
Type: GFB-60/30RE
Year: 2007
SER. N.: 034-041733
Voltage: 220v
Frequency: 60/ 3phase
Power: 18.90 Amp
Air: 8 Bar (116psi)
Weight: 5790kg (12,738lbs)
General Information: Fully automatic Cutting table for float and patterned glass The fully automatic cutting table GFB was specifically developed for the processing of float and patterned glass. This machine provides lowest cutting tolerances and simultaneously a long life and high reliability. With the GFB you are perfectly prepared for state-of-the-art cutting requirements. The cutting table is equipped with an infinitely adjustable air cushion part and a skid- and wear-resistant conveyor belt. The infeed transport and the aligning of raw glass is performed automatically by the belt transport and then the cutting process will start automatically. The automatic cutting oil feed is performed centrally via the hollow shaft of the cutting wheel holder. The program controls the maximum speeds as well as the accelerations depending on the shape of the cut in order to ensure an optimum cutting quality. The quality of the cut is significantly improved by using an automatic cutting pressure control. An optimization of the travel distance ensures most efficient cycle times. The data transfer for straight cuts and shape cuts is done centrally via the network or an USB interface. Edge Deletion is performed with a grinding wheel
Condition: Good working condition with:
brand new drive for edge deletion, brand new motor and drive for x axis, brand new power and encoder cables from panel to motor, brand new cam followers on bridge for y-axis travel, brand new keyboard controller. Display screen has a dead spot on the display and could be replaced. Does not affect operation.
Spares include: Belts, Bearings, Sensors, Wiring, Input/output cards, Limit switches, Air cylinders and Safety reset key switches